Quick Start
Overview
This guide explains how to set up the Klowra Anima Dual Footswitch for use with Klowra Bloom Infinity series pedals. The connection and setup process is the same for all models in the series. The Klowra Limbo Reverb is used as the example below.
If you plan to use the Klowra Anima Dual Footswitch with other devices, please refer to the user manual for the specific device.
Connection and Activation
Use the included 1/4” (6.35 mm) TRS cable:
-
Connect one end to the TRS jacks.
-
Connect the other end to the CTRL jack on the Limbo Reverb.
Once connected, the Limbo Reverb will flash red and automatically enter Calibration Mode.
*Tip: Always use a TRS cable. Using a TS cable may prevent the device from being detected or cause an incorrect control range.*
Calibration
Once connected, the Limbo Reverb indicator will flash red to indicate Calibration Mode. While in this mode, repeatedly tap all the footswitches on the Anima.
The device will automatically exit Calibration Mode after approximately 5 seconds, at which point it is ready for normal operation
Not working after calibration?
If the pedal does not respond correctly after calibration, try the following:
-
Unplug and reconnect the cable on both ends.
-
Confirm the Anima is connected to the TRS jack and the Limbo Reverb is connected to the CTRL jack.
-
Re-enter Calibration Mode and immediately tap all the switches on the Anima quickly and repeatedly.
-
If the issue persists, try a different 1/4” (6.35 mm) TRS cable.
TRS MAP Switches
Assigns the footswitches to the TRS jack contacts.
Settings:
-
T:A / R:B
-
T:B / R:A
(T = Tip, R = Ring)
Note: This switch only changes the signal mapping of the TRS jack output.